Using the unit with a car audio
system
Use only the supplied car stereo cassette adaptor
and car adaptor. Using other adaptors can cause
overheating which can lead to fire.
This product comes with the car adaptor and the car
stereo cassette adaptor. Please refer to the “Installation
Instructions” (attached sheet).
Connect the car stereo cassette adaptor to [Ë] on
the unit.
(When doing this, set this unit’s volume to 10.)
Items to be purchased
For securing the unit:
≥Car mounting kit (SH-CDF20)
Note when using the car mounting kit (SH-CDF20)
Note!
≥When you switch off the car, volume and sound quality
may return to the original settings and the resume
function may work even if you change the disc.
≥It may not be possible to use the unit with some types
of car stereos owing to restrictions imposed by the
construction of the car stereo cassette adaptor.
For further details, refer to the instructions of the part
concerned.
RQT6481
Using the Unit with Optional Accessories
5
O
P
E
N
H
O
LD
V
O
L
E
Q
MEMORY
/
RECALL
MODE
L
R
Headphone jack (Ë)
Other equipment
(White)
(Red)
Stereo connection cable (not included)
To CD or
AUX
terminals
1Remove the screw from
the bracket at the rear
of the car mounting
base.
2
Replace the screw in the
lower hole of the bracket.
Bracket
Screwdriver
Using the unit with an audio system
Using stereo connection cable (not included), you can
listen to CDs on your audio system.
≥Turn off this unit and the other equipment before con-
nection.
≥Do not connect the cable to the PHONO jacks on the
amplifier.
≥Obtain the optional connecting cable if the other equip-
ment comes with mini-phone jacks.
≥Adjust the volume on the other equipment.
≥Set this unit’s volume to 10.
How to use the hook and loop fastener
To prevent misplacement of the remote control, it is re-
commended that the hook and loop fastener be used as
shown in the figure below.
≥Adhere the hook and loop fastener roughly in the cen-
ter of the remote control’s back surface.
≥Before adhering the hook and loop fastener, choose a
flat and even surface and wipe off any dirt.
≥Avoid a location which is exposed to direct sunlight.
Using the Wireless Remote Control
SL-SX392C ONLY
Preparation
Installing the lithium battery
Note!
≥The wireless remote control can be operated regard-
less of the hold mode of the unit.
≥Do not place any object which will block the path of
the signals between the remote control and the unit.
≥Do not allow the remote sensor or transmitter to be-
come dusty.
≥Do not leave the remote control in direct sunlight or in
high temperature locations in a car.
≥In the interest of traffic safety, do not operate the re-
mote control while driving.
≥Take every care to prevent small children from putting
the lithium battery in their mouths or swallowing it. In
the event that a child has swallowed a battery, consult
a physician immediately.
2
1
Operation
Preparation:
When the unit is to be operated using rechargeable batteries or dry cell batteries, first press [1/;] on the unit and
then use the remote control. (You cannot turn the unit on by remote control if it is powered by batteries.)
Press to start play.
Press to pause.
(Press again to restart play.)
Press to stop play.
Press and hold to turn the unit
off.
Press to skip tracks.
(Press twice to skip to the begin-
ning of the previous track.)
Press and hold to rewind or rapid
forward.
Press to change play mode.
(The mode switches each time
this is done to 1-track repeat, all-
track repeat, random and random
repeat.)
Remote control’s operating range
≥Point the transmitter on the remote control at the re-
mote sensor on the unit.
≥Use the remote control within a 7-meter range of the
remote sensor on the unit.
≥(Depending on the angle of the remote control, the sig-
nals may not reach the sensor.)
12
CAUTION:
The battery used in this device may present a risk
of fire or chemical burn if mistreated. Do not
recharge, disassemble, heat above 100eC (212eF),
or incinerate. Replace battery with Panasonic part
number CR2025 only. Use of another battery may
present a risk of fire or explosion.
Dispose of used battery promptly. Keep away from
children.
Do not disassemble and do not dispose of in fire.
2
1
1
;
∫
9
5
:
6
MODE
“i” side facing down.
Back of the remote control
Back of the
remote control
VOL
The volume level is controlled
between 0 and 25.
i: Increase the volume level
j: Decrease the volume level
(Level 10 is recommended.)