Filter
Top Products
5
Using the Unit with Optional Accessories
L
R
Headphone jack(Ë)
Other equipment
(White)
(Red)
Stereo connection
cable
(not included)
CD or AUX
RQT5961
1Remove the screw from
the bracket at the rear
of the car mounting
base.
2
Replace the screw in the
lower hole of the bracket.
Bracket
Screwdriver
Using the Wired Remote Control
To start play
To stop play
To turn off
the unit
The remote control can be operated regardless of the
HOLD mode of the unit.
Preparation:
Release the remote control from the HOLD mode.
∫ Operation confirmation tones
» When an operation button is pressed, a confirmation
tone sounds. Refer to the parentheses in the illustra-
tion for the different types of confirmation tones.
Basic operation
Skipping
tracks
Searching
through tracks
To adjust the
volume
Press once during off or stop mode.
Press once during play.
Press and hold during play or stop
mode.
HOLD
(Beep)
(Beep...Beep)
(Beep...Bee...p)
Other operations
To change sound quality
See page 4.
Press during play.
(Press [:] twice to skip to the beginning of
the previous tracks.)
Press and hold during play.
VOL
Forward
(Beep Beep)
Backward
(Beep Beep Beep)
≥The volume range is 0–25. (Press and hold
to change the volume successively.)
≥A tone (beep-beep) sounds when you
reach the minimum or maximum volume.
Decrease
(Beep)
Increase
(Beep)
Maintaining the
Lens
Open the lid and clean the lens as shown in the figure.
Use a cotton swab to gently wipe off any finger-prints.
Recommended product: Lens cleaner kit (SZZP1038C)
Air blower for
camera lens
Lens
Lens
Using the unit with a car audio
system
Items to be purchased
For connection to the car audio system
Car stereo cassette adaptor (SH-CDM10A)
Connect the car stereo cassette adaptor to the
unit’s headphone jack.
(When doing this, set this unit’s volume to 10.)
For securing the unit and connecting the power
supply:
≥Car adaptor (SH-CDC9)
≥Car mounting kit (SH-CDF20)
Note when using the car mounting kit (SH-CDF20)
Note!
≥When you switch off the car, volume and sound quality
may return to the original settings and the resume
function may work even if you change the disc.
≥It may not be possible to use the unit with some types
of car stereos owing to restrictions imposed by the
construction of the car stereo cassette adaptor.
For further details, refer to the instructions of the part
concerned.
Using the unit with an audio system
Turn off this unit and the other equipment before operation.
1 Connect the remote control to the unit's
headphone jack.
2
Connect the stereo connection cable to
the remote control's headphone jack and
the terminals on the other unit.
The unit may malfunction if you connect this cable
directly to the unit.
3 Set the volume to 10.
Make further volume adjustments with the other
unit.
4 Control play with the buttons on the main
unit.
The tone will be heard if you use the buttons on the
remote control.
For your reference:
≥Obtain the optional connecting cable if the other equip-
ment comes with mini-phone jacks.
≥If you connect speakers (active or otherwise) directly to
the unit's headphone jack, ensure they have an imped-
ance of 1 k≠ or less.
Note!
Do not connect the cable to the PHONO terminals on
an amplifier.
Wired remote control