Filter
Top Products
8
RQT6771
Change the frequency step according to the area.
Preparation: Press [RADIO/BAND] to switch on the power.
Press and hold [RADIO/BAND]
until the step appears.
Within 10 seconds
Press to select the step.
Each time you press [j
:
,
9
i]
Within 10 seconds
Press and hold [MEMORY/RECALL] until the frequency appears
to confirm the step.
∫ To return to the previous frequency step
Repeat the above procedure.
≥Changing the step erases the stations you stored in memory.
To obtain good reception
To select stereo or monaural FM
When using overseas
TUNING
MODE
RADIO/
BAND
OPR OFF
VOL
–CITY/
NOR
FM RECEPT
FM MODE
MONO/ST
MEMORY/
RECALL
S-XBS
MODE
TUNING
MODE
RADIO/
BAND
OPR OFF
VOL
–CITY/
NOR
FM RECEPT
FM MODE
MONO/ST
MEMORY/
RECALL
S-XBS
MODE
OP
EN
MONO
FM U0.2 FM U0.1 E
Changing the sound quality
AM
Try various directions to obtain
optimum reception.
FM
The headphones/earphones cord is
also the FM antenna, so extend it instead of leaving it coiled.
Set to “MONO” when there is noise during FM reception.
Sound becomes monaural, but noise is reduced.
Each time you press [FM MODE MONO/ST]
The operation is the same as when playing CDs. (
➪
page 6)
To receive an FM broadcast clearly
Set to “CITY” if reception is poor or if there is interference from another
station.
Each time you press and hold [FM RECEPT %CITY/NOR]
CITY
No display
(canceled)
FM 0.2 MHz,
AM 10 kHz
(original setting)
FM 0.1 MHz,
AM 10 kHz
FM 0.05 MHz,
AM 9 kHz
No display
(stereo)
1
2
3