Filter
Top Products
4
RQTT0585
Concerning the remote control
Using a household AC outlet
Connect the AC power supply cord firmly to the
unit and the outlet.
Using batteries (not included)
The unit cannot be powered by batteries if the
AC power supply cord is connected.
Memory back-up
Insert batteries (not included) to save the current
time, timer settings and radio stations you have
set. If memory batteries are not used, memory
items are erased in the following situations:
• Power failures,
• The AC power supply cord is disconnected
from the power outlet,
•
The AC power supply cord is connected to the
unit while the unit is being powered by batteries.
These batteries do not power the unit.
Household AC outlet
(AC 120 V, 60 Hz)
AC power cord
(included)
When to change the batteries
When the battery indicator begins flashing,
replace all 6 of the batteries. It is also a good
idea to replace all the batteries before recording.
(R14/LR14, C, UM-2)
Inner row
Outer row
(R6/LR6, AA, UM-3)
When to change the batteries
The batteries last about a year.
Connect the unit to AC power before replacing
the batteries.
Before connecting or disconnecting the AC
power supply cord, press [TAPE/OFF] and stop
the tape to turn the unit off. The memory
batteries are worn out faster if the cord is
disconnected with the power still on.
Removing the batteries
Open the battery cover and insert your finger in
the hole on the bottom of the unit and push out.
(Remove the power batteries first.)
Battery installation
Insert the batteries (not included) observing the correct polarities ( , ).
Operation notes
• Do not place obstacles between the remote control signal sensor and
the remote control unit.
• Do not expose the remote control signal sensor to direct sunlight or to
the bright light of fluorescent light.
• Take care to keep the remote control signal sensor and end of the
remote control unit free from dust.
To prevent damage
• Never place heavy items on it.
• Do not disassemble or reconstruct it.
• Do not spill water or other liquids into it.
Correct method of use
Transmission window
About 7 meters in front
of the signal sensor
Remote control
signal sensor
Note
Before playing starts the battery indicator may
flash although the batteries are not drained. It
appears correctly once you start play.
Note
The included AC power supply cord is for use
with this unit only. Do not use it with other
equipment.
1
2
1
2
(R6, AA, UM-3)
Power sources
For R14/LR14, C, UM-2
For R6/LR6, AA, UM-3
The unit can be powered with household AC power or dry cell batteries (not included).
Insert memory batteries (not included) to save the current time, stored timer settings and radio stations.