Filter
Top Products
BEFORE PLAYBACK
Turningon and off
Turning the power on
Turningoff the power
Standby mode
Adjusting the sound
Volume
Press PLAY/PAUSE. Power is turned on and
playback starts.
If no new operations are done within seconds
from the end of last operation, the power is turned
off automatically. (Auto power off function) you can
turn off the power before it is automatically turned
off by pressing STOP
mode until the auto power off function automatically
turns off the power.
To enter standby mode, press PLAY/PAUSE to
start playback, then press STOP
Turn the VOLUME control to adjust the volume.
X-BASS
Switch on the X-BASS for extra bass emphasized.
D
D
E
the pivot gently.
Pick up the disc, holding its edge, while pressing
To removethe disc
G
3. Close the disc compartment.
2. Place a disc in the center with the label side facing up.
1. Push the OPEN switch to open the disc compartment
Inserting a disc F
HOLD switch
When not using the unit, set the HOLD switch to the
ON position, Accidentally pressed button will not
function. If buttons are pressed when the HOLD
switch is set to the ON position. "HOLD" will light on
the display.
D
Release the
HOLD
switch to
OFF
position before playback.
When an operation finishes, the unit goes into standby
BASS
D
E
F
G
E
30