Filter
Top Products
14
Using the RI Dock—Continued
While the OSD mode is set to On, you can set
the RI Dock’s video output to PAL or NTSC.
If the onscreen display looks distorted on your
TV, try changing the TV system.
•While pressing and holding down the
[SETUP] button, press the VOLUME Up [ ]
button for more than 3 seconds to select
NTSC, or press the VOLUME Down [ ] but-
ton for more than 3 seconds to select PAL.
■ Functions
Depending on your amp and generation of
iPod, you may also be able to use the following
functions.
•System On Function
When you turn on your amp, the iPod turns on
as well. With some amps, you may need to
press the [ON] button on your amp’s remote
controller’s twice to turn on the other compo-
nents in your system.
•System Off Function
When you turn off your amp, the iPod turns off
as well.
•Auto Power On Function
*
If you start iPod playback while your amp is on
Standby, your amp will automatically turn on
and select your iPod as the input source. Then,
your iPod will start playback.
•Direct Change Function
*
If you start iPod playback while listening to
another input source, your amp will automati-
cally select your iPod as the input source.
•Timer Play
You can use your amp’s Timer function to turn
on your amp and iPod and start playback at a
specified time.
•Using Your Amp’s Remote Controller
You can use your amp’s remote controller to
control basic iPod functions (see page 16).
Setting the TV System (European
model only)
Other Functions
*If you use your iPod’s controls to start an iPod slideshow or
video, these functions will not work, so use the remote con-
troller instead.
Note:
•Your amp may take several seconds to
startup, so you might not hear the first
few seconds of the first song/video.
Operating Notes:
•The RI Dock must be connected to your
amp with both an cable and an audio
cable to use the functions.
•If your amp doesn’t support the System
On, System Off, Auto Power On, and
Direct Change functions, you’ll need to
turn your amp on and off and select the
input source manually.
•Before you select another input source,
stop iPod playback to prevent your amp
from selecting the iPod input source by
mistake.
•If any accessories are connected to your
iPod, your amp may not be able to select
the input source properly.
•While your iPod is in the RI Dock, its vol-
ume control has no effect. If you adjust
your iPod’s volume control while it’s in the
RI Dock, make sure it’s not set too high
before you reconnect your headphones.