Nady Systems PSS-150 Portable Speaker User Manual


  Open as PDF
of 8
 
OUTPUT POWER 75 watts �MS per channel into 4 Ohms load
OVERLOAD PROTECTION AMA™(AutomaticMaximumAmplitude)servosystemlimitsthepoweramplierinputto
prevent clipping distortion that can damage speakers
FREQUENCY RESPONSE 40 Hz to 20 KHz measured at 1 watt
TONE CONTROLS Bass: 100 Hz ±+/-10 dB; Treble: 10 KHz +/-10 dB
GRAPHIC EQUALIZER 5 bands; 100 Hz, 350 Hz, 1 KHz, 3 KHz, and 8 KHz with FLI™ (Feedback Locating Indicators)
DSP EFFECTS Hall/�oom/Plate �everbs, Chorus, Flanger, Delay, Vocal Cancel, Chorus/�oom, �otary Speaker
INPUT IMPEDANCE Mic input: 2 K Ohms, Line input: 12 K Ohms
MAX GAIN 86 dB mic input to speaker output
DISTORTION Less than 0.8% THD at rated output
SIGNAL / NOISE RATIO 85 dB mic input typical
REVERB/DELAY DSP digital reverb and digital delay
SPEAKERS Woofer 10” (254mm) and piezoelectric horn tweeter
AC POWER 120 VAC (60 Hz) or 230 VAC (50/60 Hz)
DIMENSIONS 27.6” x 15.75” x 23.4” (70.2 cm x 40 cm x 59.4 cm)
WEIGHT (assembled) 59.4 lbs (27Kg)
MICROPHONE Unidirectional (cardioid) dynamic
(18) (16) (17) (19)
(16) FUSE HOLDER & POWER CORD CONNECTOR
This fuse holder contains an AC primary fuse. When this fuse blows,
replace it with the same type fuse, size and power rating (see
SPECIFICATIONS). If it continuously blows, stop replacing the fuse
andreferservicingtoqualiedpersonnel.Thecordconnectoris
usedtoconnecttheACpowersourcetoyourpoweramplier.
(CAUTION: After checking the AC supply voltage, be sure that the correct
fuse is in the fuse holder.)
(17) AC VOLTAGE SELECT SWITCH
Before plugging in the power cord, check to see that the unit is set
for the proper voltage for your area: ~115V (60Hz) or ~230V (50Hz).
(Note: use at the improper voltage can damage your unit and void the
warranty.)
(18) POWER SWITCH
Use this switch to power unit ON or OFF. Before turning on this
unit, verify connection to the proper voltage AC source, check all
connections and turn down the level controls of equipment connected
to the outputs.
(19) SPEAKER 1/4” OUTPUT JACKS
Connect to the left and right PSS-150 speakers.
7
Rear Panel Controls & Connections
Specications
 previous