Filter
Top Products
SP-400 Series User’s Guide
Installing and removing the battery pack
To install the battery pack:
Hold the transceiver’s body with one hand and the battery pack
with the other.
1. Slide the bottom of the
battery pack into the s
on the bottom of the
transceiver.
lots
2. Gently push the top of
the battery pack toward
the transceiver until a
click is heard. The
battery pack will snap
into place and should be
firmly locked.
To remove the battery pack:
1. Press the battery release
button located on the
back of the battery pack.
2. Hold the release button
and gently lift the top of
the battery pack away
from the transceiver.
3. Remove the battery pack
by separating it from the
transceiver’s body.
Installing and removing the belt clip
The supplied belt clip allows you to attach the transceiver to your
belt, while the radio is not in use or is in receive mode. The radio
should be held as instructed in the “Transmitting to other radios”
section while transmitting.
© 2005, Midland Radio Corporation 13