Filter
Top Products
Customising using Config 39
DSP5000 User Guide
You get to source menu 4 by using the menu
e key while in source
menu 1.
The display will be like this:
cd 1A
The first part of the display tells you which key on the MSR you are
setting up. The second part of the display tells you the address. Normally
you should leave this set to ‘1A’ unless advised otherwise by your dealer
or Meridian technical support.
Use the
n and s menu keys to select the second part of the display.
Completing Config
When you are happy with your left/right and master/slave choices, and
with your other choices for this speaker:
1. Switch off the DSP5000, using the power switch on the back
2. After a second, switch the DSP5000's power on again
Note Ensure that you have set the two speakers to opposite settings. One
must be left, the other right; similarly, one must be the master and the
other a slave.
3. Make a note of your choices by marking both speakers on the back in
the area provided on the label. Use a pencil so that you can change
the marking in future.
Note When customisation is complete, switch the power off, wait for 3
seconds, then switch it on again to restore Normal operation and to save
what you have done.
Customising using Setup
Features of Setup
Setup provides additional functions:
• Choice of wall alignment for the low-frequency response of the
speaker
• The Store key takes on a ‘Store’ capability
• Access to DSP Centre-channel features.
How to use Setup
Note It is not necessary to make any adjustments to the slave for Setup.
1. Switch off the master DSP5000, using the power switch on the back,
and wait for 3 seconds
2. While pressing the Store key on the remote control, switch the power
on again. The display will momentarily show
SEt
3. Release the Store key
The master will revert to the Standby display and condition. You may now
use the speakers normally.
When customisation is complete and you are sure that you have stored
the correct tone settings independently for every source you wish to
change:
1. Switch the power off and then on again to restore Normal operation
For an overview
of Setup, see
page
31