Filter
Top Products
6
INSTALLATION
Unravel the AC cord and connect it to a
conveniently located AC outlet having 120V
and 60Hz only. The Clock Display will
illuminate and “12:00” will blink in the window.
NOTE: If the AC plug does not fit into a
nonpolarized outlet, do not file or cut the wide
blade. If the AC plug does not fit into a
nonpolarized AC outlet, do not file or cut the
wide blade. It is the user’s responsibility to
have an electrician replace the obsolete outlet.
If the AC cord is disconnected or if there is a power failure, this electronic clock is
designed to continue operating internally (without showing the time on the Clock
Display) with a 9 volt battery (not included). To install the battery, connect the
battery to the terminals of the battery snap inside the compartment (use of an
alkaline battery is recommended).
Be sure to check the condition of the battery
periodically by disconnecting the AC cord and
connecting it again two or three minutes later. The
preset times should continue operating. If the present
time does not appear, it indicates the battery is dead
or not connected properly. The 9 volt battery will keep
the internal times accurately for approximately 30
minutes. If the power is restored after 30 minutes, the
times may need to be reset.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
4. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer’s directions.)
CR1100.O/M.QXD 4/16/02 3:51 PM Page 6