Filter
Top Products
15. OVERLOADING
D
o not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
16. OBJECT AND LIQUID ENTRY
Never push objects of any kind into this product through openings as they may touch dangerous voltage points
o
r short out parts that could result in fire or electric shock. Never spill or spray any type of liquid on the product.
1
7. OUTDOOR ANTENNA GROUNDING
If an outside antenna is connected to the product, be sure the antenna system is grounded so as to pro-
vide some protection against voltage surges and built-up static charges. Section 810 of the National
Electric Code, ANSI/NFPA70, provides information with respect to proper grounding of the mast and sup-
porting structure, grounding of the lead-in wire to an antenna discharge product, size of grounding conduc-
tors, location of antenna discharge product, connection to grounding electrodes and requirements for
grounding electrodes.
18. SERVICING
Do not attempt to service this
product yourself as opening or
removing covers may expose you
to dangerous voltage or other
hazards. Refer all servicing to
qualified service personnel.
19. REPLACEMENT PARTS
When replacement parts are
required, be sure the service tech-
nician uses replacement parts
specified by the manufacturer or
those that have the same charac-
teristics as the original part.
Unauthorized substitutions may
result in fire, electric shock or
other hazards.
20. SAFETY CHECK
Upon completion of any service
or repairs to this product, ask the service technician to perform safety checks to determine that the product
is in proper operating condition.
21. WALL OR CEILING MOUNTING
The product should be mounted to a wall or ceiling only as recommended by the manufacturer.
22. DAMAGE REQUIRING SERVICE
Unplug the product from the wall outlet and refer servicing to qualified service personnel under the follow-
ing conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled or objects have fallen into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions, as an adjustment o other controls may result
in damage and will often require extensive work by a qualified
technician to restore the product to its normal operation.
e. If the product has been dropped or the cabinet has been damaged.
f. When the product exhibits a distinct change in performance–this
indicates a need for service.
23. HEAT
The product should be situated away from heat sources such as radiators, heat registers, stoves or other
products (including amplifiers) that produce heat.
24. NOTE TO CATV SYSTEM INSTALLER
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular
, specifies that the cable ground shall be con-
nected to the grounding system of the building, as close to the point of cable entry as practical.
SAFETY INSTRUCTIONS (CONTINUED)
5
EXAMPLE OF ANTENNAGROUNDING AS PER
NATIONALELECTRICAL CODE