Magnavox mcr140 Clock Radio User Manual


 
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24 hour alarm reset option will be automatically selected after
59 minutes, from the time your alarm time first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain the
same alarm setting for the following day:
Press SET TIME/ALARM OFF during the alarm call.
CANCELING THE ALARM COMPLETELY
To cancel the set alarm time before it goes off, or during the alarm call:
Adjust OFF/ON/AUTO/BUZZ to OFF position.
REPEAT ALARM
This repeats your alarm call at 7-8-minute intervals.
1
During the alarm call, press
REPEAT ALARM
.
2
Repeat if desired for up to 59 minutes.
SLEEP
This set has a built-in timer which enables the set to be automatically switched
off during radio playback after a set period of time. This allows you to lie back,
listen and fall asleep. The maximum sleep time is 59 minutes.
Setting SLEEP
1
Set OFF/ON/AUTO/BUZZ to OFF position.
2
Set your sleep time by pressing on the SLEEP button. Keep your finger on the
button and the display will begin to count down from 0:59 to 0:00 minute.
To cancel sleep, press
SET TIME/ALARM OFF
.
To view the remaining sleep time, press SLEEP.
MAINTENANCE
If you do not intend to use the set for a long time, withdraw the power plug
from the wall outlet. In addition to this, it is advisable to remove the battery
from the clock radio. This will prevent any danger of leakage and the clock
radio will not be damaged.
Do not expose the set to humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
To clean the set, use a soft, slightly dampened chamois leather. Do not use
any cleaning agents containing alcohol, ammonia, benzene or abrasives as
these may harm the housing.
ENVIRONMENTAL INFORMATION
We have reduced packaging to the minimum for easy separation into two materi-
als: paper and cardboard.
Your set consists of materials which can be recycled if disassembled by a special-
ized company. Please observe local regulations on the disposal of packing materi-
als and old equipment.
The set complies with the FCC-Rules, Part 15.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the warranty. Do not open the set as there is a risk of
electric shock.
Problem
Possible Cause
Remedy
No sound/power
Volume not adjusted
Adjust the volume
Occasional crackling sound during FM broadcast
Weak signal
Adjust the position of the power cord
Continuous crackling/hiss disturbance during AM broadcast
Electrical interference from TV, computer, fluorescent lamp, etc.
Move set away from other electrical equipment
The alarm does not function
Alarm time not set and or alarm mode not selected
Set
the alarm time and / select alarm mode
Volume too low for RADIO
Adjust the volume
Radio alarm not adjusted to radio station
•Tune to a radio station