Magnadyne MV855 Portable DVD Player User Manual


 
Quality installations are best
performed by qualified and
certified installers.
Donttouch the unit if there is
a flash of lightning. You may
receive an electric shock.
Do not cover or stop up heater
ducts or vents. It may cause a
fire or receive an electric shock.
Watching the monitor for an
extended period of time
without the engine running
may deplete the vehicle s
battery charge.
This product is designed for
operation with a 12 Volt DC,
negative ground vehicle. It
is not suitable for operation
under other conditions or
voltages.
CAUTION
Operating Notes
Do not bring magnetic devices
such as credit card or magnetic
card near the magnets.
1. The operating temperature of this product is limited to 14 ~+140 F.
2. If your vehicle is extremely hot or cold you must allow time for your air
conditioner or heater to cool or heat the vehicle until operating temperatures
have returned to normal operating ranges.
3. Optimal picture quality is achieved when viewed from directly front of the
monitor (+/-30˚).
refeR.flesruoydnagnisuohehtnepotonoD.4
servicing to qualified personnel.
5. DVD Players use an invisible laser beam which can cause hazardous radiation
exposure. Be sure to operate the unit correctly as instructed.
6. Do not cut the car power supply off whileadisc is playing. It can cause
damage to the DVD Player.
attempt to make any repairs
4
Caution
Troubleshooting
Symptom
Items to Check
Actions to be Taken
Remote controldoes
not workproperly.
Is thepower turned on?
Is theaudio which is connected with
the audiocable set to receive
the DVDsignal output?
Is audiocable connected securely?
Is themonitor which is connected
with theaudio cable turnedon?
Is theaudio output set
in thecorrect position?
Is theremote control facing
the remotesensor?
Is thedistance too far?
Is thereany obstacle in the middle?
Is thebattery weak?
Check thecar battery capacity.
Select the correct inputmode for theaudio receiver.
Connect the audio cableinto the jackssecurely.
Turn on the monitor connectedwith the audiocable.
Set theAudio Output to the correctposition,
and thenturn on the DVDplayer again by pressing
the POWERbutton.
Point theremote control towardthe remote sensor of
the product.
Use theremote control within15 feet.
Remove theobstacle.
Replace withnew battery.
Buttons do not work.
No sound
When a disc is brought from a cold environment toawarm one, there may be moisture
on the the disc, or condensation on the pickup lens. It wil
l affect disc playback.
1. Remove the disc from the DVD player.
2. Turn on the power and leave it on for an hour to vaporize the condensation.
35
Moisture or condensation on lens