Filter
Top Products
11
G. TIME ALARM
The projection alarm has two separate alarms for time, “ALM1” and “ALM2”. The alarms
have a different sound; ALM1 increases in volume after 25 seconds, and again after 50
seconds. ALM2 is a constant volume. The total duration is 96 seconds for each alarm.
1. SETTING THE ALARM
a. Press and hold “ALM1” OR “ALM2” for two seconds until the alarm time is
flashing.
b. Press and release “ALM1/HOUR” to advance the hour, and “ALM2/MIN” to
advance the minute. The time will display “PM” if set to PM, and nothing if set to
AM.
c. The projection alarm will revert to normal operation when no buttons are pressed
for 15 seconds. The alarm is now set and activated.
2. ACTIVATING/DEACTIVATING THE ALARM
a. After entering the alarm setting mode,
the alarm is activated (either ALM1 or
ALM2).
b. To toggle between activating and
deactivating the alarm, press either the
ALM1 or ALM2 briefly. “(((1)))” or
“(((2)))” will be displayed to the right of
the time display when the alarm is
activated.
c. When the snooze bar is pressed, the
display will scroll through the alarm 1
and 2 times in the lower left.
3. TURNING ALARM OFF (WHILE SOUNDING)
a. While either alarm is sounding, press and release the SNOOZE bar to disable
the alarm for the set duration (Section II. D.). If the duration is set to “0”, the
alarm will be disabled for 24 hours.
b. After the SNOOZE bar is pressed, the lower left will display the time remaining
on the snooze. The SNOOZE bar may be pressed at any time to restart the
snooze duration.
c. To disable the alarm for 24 hours, press and release any button other than
SNOOZE or projection keys.
H. CHANGING DISPLAY MODE (DAY, SECONDS, AND TEMPERATURE)
There are six possible display modes to view the day, seconds, and temperature (remote
temperature is constantly displayed). To change the display (starting at the default of
Day.Date.Year/Remote Temperature):
1. Press and release the “MODE/+” button. The display should now show
month.day.year/remote temperature
2. Press and release the “+” button a second time and the display will now show
seconds/remote temperature
3. Press and release the “+” button a second time and the display will now show
alarm1 time/remote temperature
4. Press and release the “+” button a second time and the display will now show
alarm2 time/remote temperature
5. Press and release the “+” button a second time and the display will now show
indoor temperature/remote temperature
6. Press and release the “+” button a second time and the display will now show
day.month.date/remote temperature
Alarm 2 activated