Filter
Top Products
15
their own set of instructions. Follow these instructions for a complete guide to
setting up. Following are some brief instructions for the basic set-up of remote
temperature sensor units with the WS-9210U. These extra remote temperature
sensors can be purchased through the same dealer as this unit, or by contacting La
Crosse Technology directly. A TX6U will monitor temperature only, a TX3U will
monitor temperature and display the temperature on its LCD, and the TX3UP will
monitor the temperature via a probe for measuring soil or water temperatures..
Note:
When setting up multiple units it is important to remove the batteries from all
existing units in operation. Then insert batteries into all the remote temperature
sensor units in numeric sequence. Second, install batteries into the indoor weather
station. Transmission problems will arise if this is not done correctly and if the
total time for set-up exceeds 6 minutes.
A. SET-UP OF MULTIPLE UNITS
1. It is necessary to remove the batteries from all units currently in
operation.
2. Remove the battery covers to all remote temperature sensor units.
3. Place all remote temperature sensor units in a numeric sequential
order.
4. In sequential order, install batteries (follow the same battery
installation procedures seen in section I. A) of the Detailed Set-Up
Guide).
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and operating
instructions.
B. VIEWING AND OPERATING WITH MULTIPLE REMOTE
TEMPERATURE SENSOR UNITS
1. To view the temperature of a different remote temperature sensor
unit, press and release the “CH” button. A shift from one “boxed”
number to the next should be observed in the OUTDOOR LCD.
2. To view the Minimum/Maximum temperature: first select which
remote temperature sensor to read data from (indicated by the
“boxed” number), then press and release the “MIN/MAX” button.
Pressing this button once will display the minimum temperature and
the date and time the data was recorded. Pressing this button a
second time (while “MIN” is still displayed, otherwise press the
button twice) will display the same data for the maximum recordings.
3. To reset the Minimum/Maximum readings, it is necessary to select
which remote temperature sensor you wish to reset. Press and hold