Filter
Top Products
23
THE REMOTE TEMPERATURE SENSOR
The remote temperature sensor can be mounted in two ways:
• with the use of screws
• using the adhesive tape
A. MOUNTING WITH SCREWS
1. Remove the mounting bracket from the remote
temperature sensor.
2. Place the mounting bracket over the desired location.
3. Through the three screw holes of the bracket, mark the
mounting surface with a pencil.
4. Where marked, start the screw holes into mounting
surface.
5. Screw the mounting bracket onto the mounting surface.
6. Ensure that the screws are flush with the bracket.
B. MOUNTING WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the back of the
mounting bracket and the mounting surface to ensure a
secure hold. The mounting surface should be smooth and
flat.
2. Remove the protective strip from one side of the tape.
3. Adhere the tape to the designated area on the back of the
mounting bracket.
4. Remove the protective strip from the other side of the
tape.
5. Position the remote temperature sensor in the desired
location, ensuring that the indoor temperature station can
receive the signal.