Filter
Top Products
4
DETAILED SET-UP GUIDE
I) BATTERY INSTALLATION
Note:
To avoid start-up problems make sure that the batteries do not spring free.
A) MOON PHASE CLOCK
1) Remove the battery
cover, located on the
backside of the unit.
2) Observe the correct
polarity, and install 2
AA batteries.
3) Replace the battery
cover.
Note:
After the
batteries have been installed a tone will sound, and all the LCD’s (Liquid
Crystal Display) will briefly light up. Then the indoor temperature, the date
as “1/ 1”, the weekday as “MON”, and the Moon Phase will be displayed.
Also, the time will appear as “-:--” for approximately 1 minute. Then the
WWVB search is automatically initiated, and a tower icon appears and
flashes with the time colon (no tower icon will appear if the WWVB is too
weak to be detected). While the WWVB search is being conducted various
numbers will appear in the time display. The numbers “0”, “1”, or “8”
will appear in the hour position and the seconds will appear in the minute
display. The Moon Phase Alarm will either display the WWVB time, or
discontinue the search after 10 minutes if the time is not found. When the
search is cancelled “-:--”will appear in the time LCD. The Moon Phase
Alarm will conduct a WWVB search every hour until the first signal is
found. Once the WWVB time is found, a search is automatically conducted
nightly at midnight. If the signal is found at midnight, the tower icon will
remain, if not, another search will take place every hour(up to 6:00 am)
until the signal is found successfully. If no signal is found during this
period, the tower icon will not appear and the clock will search again at
12:00 am the next night.