Filter
Top Products
2
QUICK SETUP
1. Insert two AAA batteries into the Remote
Control Sender.
2. Insert two AA batteries into the Indoor
Temperature Station.
3. Wait 5-6 minutes, or until the outdoor
temperature is displayed in the OUTDOOR
LCD (Liquid Crystal Display) of the Indoor
Temperature Station.
4. Set the Time (See complete instructions
for details).
5. Mount units.
Note:
The Remote Control Sender transmits a
signal every 3 minutes. After the batteries have
been installed, the Indoor Temperature Station
searches for these signals for a duration of 6
minutes. If there is no temperature reading in
the OUTDOOR LCD after 6 minutes, make
sure the units are within range of each other, or
repeat battery installation process.