Filter
Top Products
13
Air pressure
histogram
Outdoor temperature
or dew point
in °F or ºC
Wind direction display
and wind speed in
Beaufort scale
Calendar display
Weather tendency
indicator
Time display
Time alarm icon
Outdoor relative
humidity in %
Weather forecast
icon
Relative air pressure
display in inHg o
r
hPa, or total and 24h
rainfall display in inch
or mm
Wind speed or gust in
m
p
h, km/h or m/s
Wind Chill
in °F or °C
Wind speed Hi
alarm icon
Outdoor Humidity
alarm icon
Outdoor temp.
alarm icon
Low battery Indicator (rain sensor)
Low battery Indicator (Thermo-hygro)
Buzzer off indicator
Transmitter signal
reception icon
Low battery Indicator (weather center)
14
* When the signal from the transmitter/ or Rain sensor is successfully received by the
Weather Station, this icon will be switched on. (If not successful, the icon will not be
shown on the LCD). User can therefore easily see whether the last reception was
successful (“ON” icon) or not (“OFF” icon). On the other hand, the short blinking of the
icon shows that a reception is being done at that time.
*In normal display user may press the SET key shortly to toggle between Mode 1 and
Mode 2 display:
Mode 1: Wind speed, outdoor temperature and relative pressure reading are shown.
Wind speed icon
Outdoor temp
icon
Rel Pressure
icon
In Mode 1, this
reception icon is
showing the
condition of the
reception of the
signal from
Thermo-hygro
transmitter
15
Mode 2 : Wind Gust, Dew Point temperature and Rainfall reading are shown.
MANUAL SETTING:
The following manual settings can be changed once the SET key is pressed and hold
for about 2 seconds:
LCD contrast setting
Manual time setting
12/24 hour time display
Calendar setting
°F/ °C temperature unit setting
Wind speed unit
Rainfall unit setting
Air pressure unit setting
Relative pressure reference value setting
Weather tendency threshold value
Wind gust icon
Dew point icon
Rainfall icon
In Mode 2, this
reception icon is
showing the
condition of the
reception of the
signal from Rain
sensor
16
Storm warning threshold value
Storm alarm On/ Off setting
LCD CONTRAST SETTING
The LCD contrast can be set within 8 levels, from "LCD 1" to "LCD 8" (default setting
is LCD 5):
1. Press the SET key, the contrast level digit will start flashing.
2. Use the + or MIN/MAX key to adjust the level of contrast.
3. Confirm with the SET key and enter the MANUAL TIME SETTING.
MANUAL TIME SETTING:
You then may manually set the time of the clock by following the steps below:
1. The hour digit will start flashing.
2. Use the + or MIN/MAX key to set the hour.
3. Press the SET key to switch to the minutes. The minute digit will start flashing.
4. Use the + or MIN/MAX key to set the minute.
5. Confirm the time with the SET key and enter the 12/24 HOUR TIME DISPLAY
SETTING.
Flashing
Minutes flashing
Hou
r
flashing