Filter
Top Products
3
1
2
3Horn Attenuator:
Speaker Input/Output
Speaker Input/Output
This is a “volume” control for the
horn. To disable the horn, turn the
knob counter clockwise until the
indicator reaches . To set the horn
for maximum output, turn the knob
clockwise until the indicator reaches .
These jacks can be used as an input
and/or output. The jacks accept a
standard ” cable. When using
these jacks as an output to another
cabinet, refer to the Amplifier Loading
Chart (page 4) for important amplifier
loading information.
:
These jacks can be used as an input
and/or output. They accept standard
Speakon type speaker cables. To
connect a cable: Insert and twist one
quarter turn clockwise until the release
button locks. To remove a cable: Pull
back release button on cable connector,
twist connector counter clockwise one
quarter turn, and pull out connector.
When using these jacks as an
output to another cabinet, refer to the
Amplifier Loading Chart (page 4) for
important amplifier loading information.
:
0
Note:
Note:
:
¼
d
4
HORN ATTENUATION dB
Designed by Kustom Inc. Cincinnati, Ohio
MADE IN CHINA
+1 tip, -1 sleeve
+1 and -1 used
INPUT/OUTPUT
0
1
2
3
5
6
7
8
10
12
16
MODEL: GROOVE 410H
XXXX-XXXXXX
IMPEDANCE:8 OHMS
POWER: 500 WATTS RMS
SENSITIVITY:95dB 1W/1M
1
2
3
Rear Panel