Filter
Top Products
- 10 -
Press test button on transmitter to register to the clock or KA300 alarm monitor. Repeat this
process for each transmitter.
Setup clock alarms and real time
1. Press the Time and the Hour (or Minute) buttons simultaneously to change the
time setting.
2. Press Ala1 or Ala2 button and hold to check the alarm setting.
3. Press Ala1 or Ala2 and Hour (or Minute) buttons to change alarm clock setting.
4. Press Ala1 or Ala2 to turn On/Off alarm 1 or alarm 2. Both alarm 1 and alarm 2 can
be turned on at the same time. Check Ala1 or Ala2 LED indicator for alarm status.
5. Press snooze if you want the alarm to come back on 9 minutes later. To turn the alarm off
for the day, press “TIME”. If you want to stop the alarm until you turn it back on, press
“Ala1” or “Ala2”. When other monitoring alarms trigger the clock, use the snooze to reset.
Security timer (SCT)
If you are not home for a long extended period of time, and you want it to look like some
-
one is still at home, you can use the security timer feature. Every night, the clock KA1000
can turn on the table lamp connected to it for you and turn it off later at 11 pm. To pick
starting time:
1. Press SCT and Hour buttons to change security timer from 6 PM to 7, 8, 9, 10 PM.
The security timer will automatically turn off at 11 PM to make it look like someone
is at home. To make people think that a timer was not used, it will turn on/off the
lights randomly at different time every day around the setup time.
2. Press SCT to turn ON or OFF the security timer. Both alarm 1 and 2 will be disabled
in the security timer mode. Make sure to turn off SCT mode when you are back
home or the alarm will not be activated
Select mode, test, and reading lamp
Clock display dimmer:
Slide the Dimmer/Test switch to the middle position for a dim display or all the way to
test all three outputs shaker, light, and sound. It is recommended to test all outputs
every day before you turn the alarm on. Adjust the volume and shaker level to
your satisfaction.