Filter
Top Products
3. Dual units, balance.d, between p~eamplifier and amplifier(s)
Connect the left channel balanced output of your preamplifier to the
balanced input on the left channel B.A.F. Connect the balanced output
of the left B.A.F to the left balanced input of the power amplifier.
Do the same for the right channel.
Operate your system in the same manner as before the B.A.F.s were
installed. ~.~
4. Dual units, balanced or sinqle-~nded, throuqh the preamplifier
tape Ioo~
Connect the left channel Tape output of your preamplifier to the
input of the left channel B.A.F. Do the same for the right channel.
Connect the output of the left channel B.A.F. to the left channel
Tape i or 2 input of your preamplifier. Do the same for the right
channel.
When listening to the B&W speakers, the Tape Monitor should be set to
the position corresponding to the output return from the B.A.F. The
Input Selector is used to select a source for listening.
Caution: With this configuration the Input Selector must meve~ be set
to the input connected to the B.A.F. output. This will create a
feedback loop that can damage other system components.
5. After double-checking the input/output connections, connect the
power cord to the B.A.F.(s) and the other end to an AC outlet. The
unit(s) is now powered and operational.
There is no ON/OFF switch on the B.A.F. It was designed to be left on
at all times. The unit will draw less than i0 watts from the AC
powerline.
6. Turn the other system components on, remembering that the
amplifier is always the last component to be energized.
7. Enjoy