Filter
Top Products
- 5 -
Commissioning
Unpack the appliance
Remove all packing material. Remove also the trans-
portation lock from the CD compartment.
Attention!
Do not permit small children to play with the
plastic packaging. There is a risk of suffoca-
tion!
Check the items supplied
Whilst unpacking, check to ensure that all of the
following items are available:
• World Receiver
• Connector power pack
• Operating Instructions with Warranty Card
Providing mains power
This CD clock radio is operated with 230 - 240 Volt
alternating current (AC), 50 Hz. It is additionally
equipped with a back-up system for use in the event
of a power failure, for which a 9 V block battery
(not supplied) is required to be inserted.
• Connect the plug of the power pack with a wall power
socket (AC).
• Insert the 9 V block battery into the battery com-
partment
3)
on the underside of the appliance.
Take note:
The use of an alkaline battery is recommended.
In order to ensure optimum functioning, the
battery should be changed every 6 months.
Batteries are not charged in the battery com-
partment!
Battery Back-up System in Case of
Power Failures
The battery ensures that the clock continues to function
in the event of a power failure. To prolong the life,
however, the time is not shown in the display.
If a battery is not inserted, after a power failure
appears on the display. This means that you
have to carry out the time and alarm settings again.
Setting the Time
For setting the time, the appliance must be switched
off with the button
ON/OFF
u
.
Setting the time when switching on for the
first time:
• Hold the button TIME
r
pressed down to switch
between the 12h or 24h mode.
Take note:
In the display appears "12h" for the 12 hour
mode resp. "24h" for the 24 hour mode. For
the afternoon hours, an additional LED showing
"PM" now appears at the top left of the display.
• The time blinks. Using the buttons
SKIP/SEARCH
MIN and SKIP/SEARCH HR
w
programme in
the desired time.
• When you re-press the button
TIME
r
the pro-
gramming is saved. The time display no longer
flashes.
Setting the time at some later point:
• Hold the button TIME
r
pressed down to switch
between the 12h or 24h mode.
• Press the button
TIME
r
. The time blinks. Using
the buttons
SKIP/SEARCH MIN and SKIP/SEARCH
HR
w
programme in the desired time.
• When you re-press the button
TIME
r
the pro-
gramming is saved. The time display no longer
flashes.
12:00
IB_KH2254_AR4141_LB6_EN.qxd 29.02.2008 11:13 Uhr Seite 5