Klipsch AUDIO SYSTEM Portable Speaker User Manual


 
IMPORTANT SAFETY INSTRUCTIONS
Important Safety Information
1. READ these instructions.
2. KEEP these instructions.
3. HEED all warnings.
4. FOLLOW all instructions.
5. DO NOT use this apparatus near water.
6. CLEAN ONLY with dry cloth.
7. DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8. DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wider blade or the third prong is provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11. ONLY USE attachments/accessories specified by the manufacturer.
12. USE only with a cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
13. UNPLUG this apparatus during lightning storms or when unused for long periods of time.
14. REFER all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as the power-supply cord or plug is damaged, liquid has been
spilled, objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
15. DO NOT expose this apparatus to dripping or splashing and ensure that no objects filled with
liquids, such as vases, are placed on the apparatus.
16. To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug
from the AC receptacle.
17. The mains plug of the power supply cord shall remain readily operable.
The exclamation point, within an equilateral triangle, is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in the
literature accompanying the product.
The lightning flash with arrowhead symbol within an equilateral triangle, is intend-
ed to alert the user to the presence of uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient magnitude to constitute a risk of
electrical shock to persons.
WARNING:To reduce the risk of fire or electrical shock, do not expose this apparatus to rain or moisture.
WARNING: No naked flame sources – such as candles – should be placed on the product.
WARNING: Do Not Open! Risk of Electrical
Shock. Voltages in this equipment are haz-
ardous to life. No user-serviceable parts inside.
Refer all servicing to qualified service personnel.
WARNING:This product is intended to be operated ONLY from the AC Voltages listed on the back
panel or included power supply of the product. Operation from voltages other than those indicated
may cause irreversible damage to the product and void the product's warranty. The use of AC Plug
Adapters is cautioned because it can allow the product to be plugged into voltages in which the
product was not designed to operate. If the product is equipped with a detachable power cord, use
only the type provided with your product or by your local distributor and/or retailer. If you are unsure
of the correct operational voltage, please contact your local distributor and/or retailer.
CAUTION: Place the equipment near a main power supply outlet and make sure that you can easily
access the power breaker switch.
PACKING LIST
2 Satellite speakers with pedestals attached
1 Control pod, attached to one satellite speaker
1 Subwoofer
1 Packet of two individual speaker connections
1 Packet of rubber isolation feet
1 Owner's manual
SPEAKER PLACEMENT
1.The two satellite speakers should be positioned on each side of your computer monitor. To wall
mount, the pedestal stands may be removed by unscrewing the 1/4" 20-thread bolt, which
accommodates a wide variety of wall brackets available through stereo and appliance stores.
Klipsch WB-1 wall brackets are available at www.klipsch.com.
2. Place the subwoofer directly under your computer desk, or close to the satellite speakers. Do
not cover up the sub driver or rear port of the enclosure and be sure to provide enough ventila-
tion to the rear of the subwoofer. It is normal for this panel to be warm to the touch.The sub-
woofer should be at least 3 feet (1m) from the computer monitor to avoid interference.
3. Speaker or power cables running across an area of heavy foot traffic should be positioned
against a wall or corner and secured with tape.
SPEAKER CONNECTION DIAGRAM
1. Connect mini plug to PC soundcard from the control satellite preamp.
2. Connect the DIN plug to the subwoofer from the control satellite preamp.
3. Connect the speakers by inserting the tinned wire leads into the subwoofer and the back of the
satellites. The solid black wire (-) connects to the black spring clips; the black wire with white
dashes (+) to the red spring clips.
4. Do not plug in the AC power until your computer/audio system is set up.
5. Plug headphone mini stereo plug in headphone jack, if desired.
6. Plug stereo mini plug into MP3/Aux jack. Plug stereo mini plug into MP3 player (for example).
Since the ProMedia 2.1 has its own internal amplifier, it was designed to
hook into the line out connector. Connection to the speaker level output jack
might result in poor sound quality.
SOFTWARE AND HARDWARE GAIN CONTROLS
Software Volume Controls in Microsoft Windows
1. Click the Start button on your taskbar
2. Choose Accessories
3. Windows 95: Choose Multimedia
Windows 98/2000: Choose Entertainment
Windows XP: Choose Entertainment
4. Click on the Volume Control
5. Adjust the Wave Volume Elevator Button to 70%
WARNING
6
5
4
3
2
1
230 V
(iPod)
(CD Player)