Filter
Top Products
8
Installation
Installation
Tweeter Mounting continued
The tweeter can be mounted in the center of the midrange. This creates a high quality coaxial speaker. Remove the tweeter face
plate by screwing it off and install the supplied smaller face plate. Remove the magnet boot from the midrange.
Then install the tweeter back plate by securing the supplied phillips-head machine screw to the plate, as outlined in Step 1, in
Figure 4. Unscrew the bullet shaped phase plug from the center of the midrange, Step 2. Feed the wires through the included pole
mount, Step 3. Then, screw the assembly into the middle of the midrange, Step 4. Run the wire through the clip on the side of the
basket and mount the speaker in the desired location, Step 5.
Please use caution to run the wire through the channel on the back plate before clipping the wire on the basket and placing the
magnet boot back on the midrange, this prevents damage to the speaker wire in shallow mounting depth installations.
Step 2
Step 4
Step 1
Step 5
Step 3
Figure 4
RS-Series System Components