All accessories and options may not be available in all markets.
Contact an authorized Kenwood dealer for details and complete list of all accessories and options.
*To meet MIL 810 and IP grade, the 2-pin connector cover has to be connected.
Model TK-2200L VHF TK-3200L UHF
GENERAL
Frequency Range 150-174 MHz 450-470 MHz
Number of Channels
K Type 2 2
K2 Type 8 -
K3 Type - 15
Channel Spacing
Wide/Narrow 25, 30kHz/12.5,15kHz 25kHz/12.5kHz
Channel Step 2.5, 5, 6.25, 7.5kHz 5, 6.25kHz
Operating Voltage 7.5V DC±20%
Battery Life (5-5-90 duty cycle)
with KNB-45L (2000mAh) 17 hours (Battery Saver Off)
22 hours (Battery Saver On)
Operating Temperature Range -22°F ~ +140°F (-30°C ~ +60°C)
Frequency Stability ±2.5ppm (-22°F ~ +140°F)
Antenna Impedance 50 Ω
Channel Frequency Spread 24MHz 20MHz
Dimensions (W x H x D), Projections not Included
Radio Only 2.13” x 4.8” x 0.83” (54 x 122 x 21.1mm)
with KNB-45L 2.13” x 4.8” x 1.30” (54 x 122 x 33mm)
Weight (net)
Radio Only 5.6oz (160g)
with KNB-45L 9.9oz (280g)
FCC ID ALH36913120 ALH36923130
FCC Compliance Parts 22/74/90 Parts 90/95
Model TK-2200L VHF TK-3200L UHF
RECEIVER (Measurements made per TIA/EIA-603)
Sensitivity (12dB SINAD)
Wide/Narrow 0.25µV/0.28µV
Selectivity
Wide/Narrow 70dB/60dB
Intermodulation Distortion
Wide/Narrow 65dB/60dB
Spurious Response 65dB 60dB
Audio Output 500mW with less than 10% distortion
TRANSMITTER (Measurements made per TIA/EIA-603)
RF Power Output
High/Low 2W/1W 2W/1W
Spurious Response 65dB
Modulation
Wide/Narrow 16KØF3E/11KØF3E
FM Noise
Wide/Narrow 45/40dB
Audio Distortion Less than 5%
Kenwood follows a policy of continuous advancement in development.
For this reason specifications may be changed without notice.
FleetSync
®
is a registered trademark of Kenwood Corporation.
All other trademarks are property of their respective owners.
Options
Specifications
Applicable MIL-STD & IP
ADS#43507 Printed in USA
Footnotes from front:
1
DTMF Encode: PTT ID, Auto-Dial (8 numbers); DTMF Decode:
Code Squelch (3-10 digit),Group Codes A, B, C, D & Wild Card
characters) and radio Stun.
2
Call Alerting Tones: operates for DTMF & FleetSync selective call
decode only (8 factory pre-set ring patterns).
3
KPG-88D (version 2.0) required: Windows
®
98/ 2000/ Me/XP
compatible;
programs TK-2200/3200 ProTalk
®
models.
4
ID List capacity: 8 ID's.
■ KNB-45L
2,000 mAh/7.4V
Li-Ion Battery Pack
■ KSC-35K
Fast Charger
For the KNB-45L (3-Hour)
■ KRA-22
VHF Low Profile
Helical Antenna
■ KRA-23
UHF Low Profile
Helical Antenna
■ KRA-26
VHF Helical Antenna
■ KRA-27
UHF Whip Antenna
■ KRA-16
VHF Stubby Antenna
■ KRA-17
UHF Stubby Antenna
■ KMC-17
Speaker Microphone
■ KMC-21
Compact Speaker
Microphone
■ KEP-2
Earphone Kit for
KMC-17/21
(2.5mm plug)
■ KHS-7
Single Muff Headset
■ KHS-7A
Single Muff Headset
with In-line PTT
■ KHS-8BL
2-wire Palm Mic
with Earphone (Black)
■ KHS-8BE
2-wire Palm Mic
with Earphone (Beige)
■ KHS-22
Behind-the-head
Headset with PTT
■ EMC-3
Clip Microphone
with Earphone
■ HMC-3
Headset with PTT
Built-in Vox
■ KHS-23
2-wire Palm Mic
■ KMB-25
Six Unit Charger
Adapter (for six
KSC-35K chargers;
(chargers not included)
■ KBH-10
Belt Clip
■ KWR-1
Water Resistance Bag
■ KLH-126
Nylon Case
Standard MIL 810C MIL 810D MIL 810E MIL 810F
Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV
International Protection Standard
Dust & Water Protection IP54/55
