Filter
Top Products
PORTABLE DVD PLAYER V10M10_IM_EN_09182006
32
TROUBLESHOOTING GUIDE
No rapid advance (or rapid reverse) playback
• Some discs may have sections which prohibit the rapid advance (or rapid reverse.)
No 4:3 (16:9) picture display
• Choose the correct “TV SCREEN” option in the video setup page.
No operations can be performed with the remote control unit.
• Check the batteries are installed with the correct polarities (+ and –).
• The batteries may be exhausted. Replace them with new ones.
• Point the remote control unit at the remote control sensor and attempt operation.
• Operate the remote control at a distance of not more than 6m from the remote control
sensor.
• Remove the obstacles between the remote control unit and remote control sensor.
No key operation (with the main unit and/or the remote control unit) is effective.
• Press the POWER button to set the player to the standby mode and then switch back on.
• Press the POWER button to set the player to the standby mode, disconnect the power
plug, and then reconnect it.
No menu play
• This function works only for Video CDs with playback control.
Audio and/or subtitle language are not shown on the disc or not in the setup menu.
• If the audio and/or subtitle language does not exist on the language selected in the setup
menu, it will not be seen or heard.
No subtitles
• Subtitles appear only with discs which contain them.
• Subtitles are cleared from the TV monitor. Perform the steps in the subtitle setup
instruction to display the subtitles.
Alternative audio (or subtitle) language fails to be selected.
• An alternative language is not selected with discs which do not contain more than one
language.
The movie angle cannot be changed.
• This function is contingent on software availability. Even if a disc has a number of angles
recorded, these angles may be recorded for specific scenes only.
When an AC adapter is plugged in for a while, the FULL and CHARGE indicators blink.
Then, the CHARGE indicator will light up RED, but the rechargeable battery is released.
• It is a system test for the recharge circuit, which is not a malfunction.