Jensen Tools MP6312 Portable Radio User Manual


 
MP6312i
5
FRONT SP
PurplePurple/Black
Stripe
GrayGray/Black
Stripe
White/Black
Stripe
White Green/Black
Stripe
Green
Left Speaker
(Front)
Right Speaker
(Front)
Left Speaker
(Rear)
Right
Speaker
(Rear)
Black
Yellow
Blue
Red
REAR SP
FrontrLineout
R (Red)
L (White)
Black
Fuse (15 amp fast blow ATO)
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
Antenna
Connect the antenna plug
from the existing antenna
cable (some vehicles
require an adaptor).
Satellite Radio Audio In
Satellite Radio In
3.5mm
AudioOnly
MediaLink
3.5mm
Audio Only
jLink iPod Cable
(Sold Separately)
iPod NanoiPod MiniiPod
iPod Video
MediaLink Connector
Rear Line out
R (Red)
L (White)
Gray
R (Red)
L (White)
WIRING
NOTE: The amplifier in this
radio is only designed for use
with four speakers. Never
combine (bridge) outputs for
use with two speakers. Never
ground negative speaker
leads to chassis ground.
Failure to wire exactly as
shown may cause electrical
damage to the radio.
NOTE: Only connect speakers
with a nominal impedance of 4
ohms. Speakers with a load
impedance less than 4 ohms
could damage the unit.