Filter
Top Products
6. Cleaning
The unit shouldbe cleaned properly with care.
7. Objects andLiquid Entry
Care should be taken so that objects do not fall and liquids are not spilled into any opening or vents
located on the product.
8. Attachments
Do not use attachment not recommended bythe product manufacturer.
9. Lightning and Power Surge Protection
Unplug the unit from the wall outlet and disconnect the periods of time. This will prevent damage to
the product due to lightningand power-line surges.
10. Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result
in a riskof fire of electrical shock.
11. Damage Requiring Service
This unit shouldbe serviced by qualified service personnel when:
A. The power supplycord or plug has been damaged.
B. Objects havefallen into or fluid has beenspilled into theenclosure.
C. The unit hasbeen exposed to rain.
D. The unit hasbeen dropped or the enclosure damaged.
E. The unit exhibitsa marked change in performance or does not operate normally.
12. Periods of Nonuse
If the unit is to be left unused for an extended period of time, such as a month or longer, the power
cord should beunplugged from the unit toprevent damage or corrosion.
13. Servicing
The user should not attempt to service the unit beyond those methods described in the user’s
operating instructions. Service methods not covered in the operating instruction should be referred
to qualified servicepersonnel.
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interferencewill not occur in a particular installation. If this
3