Filter
Top Products
5
POWER SOURCE
This unit is designed to operate on 120V/60Hz AC house current. Operating
this unit from any other power source may cause damage to the unit, and
such damage is not covered by your warranty.
The radio is also pre-loaded with 2 x “AA” batteries for the battery back-up
and for the Auto Time Set clock system.
BATTERY BACK – UP SYSTEM
The Battery Back-up System ensures the clock and alarm settings will be
retained during a power interruption or power outage (in order to preserve
the battery life the Display will not light). All clock settings will be kept in
memory, however, the clock time may require adjustment for exact accuracy
once the power returns. If the batteries are not installed, the Display will
blink”12:00” when the power is restored. This will indicate that you have to
reset the time and alarm settings.
BATTERY INSTALLATION
1. Open the battery compartment door on the bottom of the cabinet.
2. Insert 2 “AA” size batteries into the battery compartment according
to the polarity diagram engraved inside the compartment.
3. Replace the battery compartment Door.
IMPORTANT: Be sure that the batteries are installed correctly. Wrong
polarity may damage the unit.
4. Alkaline-type batteries are recommended. For optimum performance,
these batteries should be replaced after every year or when batteries
become exhausted.
5. Old or leaking battery can cause damage to the unit and will void the
warranty.
6. Use only the size and type of batteries specified.
7. Do not mix old and new batteries.
8. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries.
9. Do not try to recharge batteries not intended to be recharged; they can
overheat, rupture and leak. (Follow battery manufacturer’s directions).
10. Do not dispose of batteries in fire, batteries may leak or explode.
POWER FAILURE INDICATOR
If there are no batteries installed in the unit or if the batteries installed are
weak or dead, the time and alarm settings will be lost if the AC power is
interrupted. When the AC power is restored the display will blink”12:00”. This
indicates that the time displayed is incorrect and needs to be reset.
IMPORTANT:
After you reset the time, be sure to reset your alarm settings as well.