Filter
Top Products
11
Installing the Array Frame
Suspension of the VRX932LA requires the VRX932LA-AF Array Frame [Warning: Do not use any substitute
for VRX932LA-AF Array Frame]. This device is attached to the VRX932LA's integral rigging using the provided
Quick Release Pins [Warning: Do not use any substitute for these pins]. Up to six (6) VRX932LA speakers
may be suspended from a single array frame.
1. Begin by attaching the two side arms (A) to either side of the center frame. Use a pair of the provided
Quick Release Pins (B) to attach the arms to the frame.
Note
: Side arms should be attached with the
rubber bumper facing up and away from the center frame. The center frame is installed with the rubber
gasket toward the enclosure and the label right side up.
2. Place the entire array frame on top of the VRX932LA and flip up the drop levers (C) found on both sides of
the speaker to be received by the array frame arms.
3. Once the drop levers on the speaker are received by the array frame, use a pair of the provided Quick
Release Pins (D) to attach the drop levers to the array frame.
Adding a Second Array Frame for Pullback
For some applications, it may be necessary to pull back the array from the bottom in order to achieve the
desired coverage. Every VRX932-AF is supplied with a spare set of Quick Release Pins pins and a pair of spare
drop levers that are used to adapt a second array frame to the bottom of a VRX932LA array. Once these are
installed on the bottom enclosure, the array frame may be attached as previously described.
Ground-Stacked, Upward Firing Arrays
Applications such as covering stadium bleachers from the playing field may be
addressed by installing the VRX932-AF array frame to the bottom of the array as
described in “Adding a Second Array Frame for Pullback.”
Up to four VRX932LA loudspeakers may be locked together and ground stacked
using the VRX932LA-AF array frame kit, as shown. [Warning: Do not ground
stack more than four VRX932LA loudpseakers in one array]. When ground
stacking VRX932LA loudspeakers, use the VRX932LA-AF array frame as the
base (as shown) by attaching the loose drop levers, included in the array frame
kit, to the lower rigging bar on the VRX932LA loudspeaker. When stacking the
loudspeakers together, make sure each loudspeaker is locked together. Be cer-
tain that the surface on which the system is to be stacked is flat, stable and solid.
(A)
(A)
(B)
(B)
(C)
(D)