Filter
Top Products
4
T
he CS600SAT is designed to be mounted on the wall. There is a
fixed-mount wall bracket and an adjustable wall bracket provided
f
or each satellite. Each speaker bracket will require up to four
1-1/2"#10
wood screws; each screw should be fastened to a wall
s
tud. If a wall stud is unavailable, install an anchor appropriate for
a 1-1/2"
#10 screw.
NOTE: The customer is responsible for the correct selection
a
nd use of mounting hardware (available through hardware stores)
that will ensure the proper and safe wall-mounting of the speakers.
Fixed-Mount Wall Bracket
S
tep 1.
M
ark the positions on the wall where you would like
to place the mounting screws.
Step 2. Attach the bracket to the wall using two screws
(not included).
Step 3. Remove the rubber ring on the bottom of the satellite, and
seat the satellite speaker onto the back bracket.
Step 4. Attach 1/4"-20 screw into insert on bottom of speaker
and tighten.
Adjustable Wall Bracket
Step 1. Remove cap over threaded insert on rear of speaker.
Step 2. Mark the positions on the wall where you would like to
place the mounting screws.
Step 3. Place bracket against the wall and fasten four 1-1/2" #10
wood screws through the bracket’s screw holes into the wall.
If a wall stud is not available, use an appropriate anchor.
S
tep 4.
U
nscrew round collar (C) from bracket (A).
Step 5. Screw the ball and shaft assembly (B) to the 1/4"-20 insert on
t
he back of the satellite (do not use the bottom insert on the speaker).
Back out 1/2 of a turn and tighten the nut against the speaker. If the
b
all and shaft assembly is not backed out before tightening the nut,
performing Step 8 below may dislodge the threaded insert in the
speaker housing and permanently damage the speaker.
Step 6. Attach speaker wire as shown on page 5.
Step 7. Drop round collar (C) over ball and shaft assembly (B) that
is mounted to the speaker with the finished side of the collar facing
the rear of the speaker.
Step 8. Carefully push the ball straight into the socket mounted on
the wall, angle the speaker as desired and tighten the collar using
the enclosed metal bar.
Figure 3. Bracket on wall.
Metal bar
Metal bar
A
B
C
Metal bar
W
ALL-MOUNTING THE SATELLITES
CS600 OM.qxd 11/28/06 2:32 PM Page 6