I/O Magic EXP3365 MP3 Player User Manual


 
TROUBLESHOOTING
WARNING: Under no circumstances should you try to repair the set yourself as
this will invalidate the warranty. If a fault occurs, first check the points listed
before taking the unit for repair. If you are unable to solve a problem by following
these hints, consult your dealer or service center.
The CD player has no power, or playback does not start
•Check that your batteries are not empty, that they are inserted correctly, that
the contact pins are clean.
•Your adapter connection may be loose. Connect it securely.
For in-car use, check that the car ignition is on. Also check the player's batter-
ies.
The indication pls insert CD or No audio file is displayed
•Check that the CD is clean and correctly inserted (label-side upward).
If your lens have steamed up, wait a few minutes until the lens clear up.
•CD-RW (CD-R) was not recorded properly. Use FINALIZE on your CD-recorder.
The indication Hold is on and/or there is no reaction to controls
If HOLD is activated, then deactivate it.
Electrostatic discharge. Disconnect power or remove batteries for a few sec-
onds.
Music files do not play
Check that the file names of MP3/WMA files end with .mp3 or .wma.
TROUBLESHOOTING
Some directories missing on MP3/WMA CDs
•Check that the total number of files and albums on your MP3/WMA CDs does
not exceed 350.
•Only albums with MP3/WMA files are shown.
The CD skips tracks
The CD is damaged or dirty. Replace or clean the CD.
Resume, shuffle or program is active. Switch off whichever is on.
Music skips or popping sounds when you play a MP3/WMA track
Play the music file in your computer. If the problem remains, encode the audio
track again and make a new CD.
No sound or bad sound quality
Playback on pause. Press 2;.
Loose, wrong or dirty connections. Check and clean connections.
•Volume might not be appropriately adjusted. Adjust the volume.
•Strong magnetic fields. Check the player's position and connections. Also keep
away from active mobile phones.
CAUTION
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.