Filter
Top Products
10
Insignia NS-CLVR01 Clock Radio with Voice Command
www.insigniaproducts.com
Using your clock radio
Turning your clock radio on and off
To turn your clock radio on and off:
1 Press and hold
/SOURCE for two seconds. Your clock radio
turns on.
2 Press DIMMER on the back of your clock radio to set the display
backlight of the LCD to a comfortable level.
3 Press and hold
/SOURCE again to switch your clock radio to
standby mode.
Using voice commands
To use voice commands:
1 To activate the voice interactive commands, make sure that the
voice control button on the back of the clock radio is set to on (the
“VC” indicator appears on the LCD display).
2 Say “Voice Command” to the clock radio or press the SNOOZE/
SLEEP/VOICE COMMAND button. The clock will respond “What
can I do for you?.”
Note
Voice commands are recognized in English only.
Tips
• Keep the background fairly quiet.
• Speak clearly and in a normal tone.
• Give correct commands (refer to command list below).
• Do not give commands when the clock radio is speaking.
• Speak near the microphone located on the top of the
clock radio.
Note
When the clock radio is waiting for your commands, always
respond within three seconds. If no response is received
from you within this time, the clock will reply “Sorry, I did not
recognize your command.” The clock radio will revert to
standby mode if it asks this more than two times. You will
hear “Sorry, I am having trouble understanding you. Please
try again later” before it quits.
NS-CLVR01_10-0138_MAN_ENG_V2.fm Page 10 Tuesday, February 2, 2010 3:04 PM