Filter
Top Products
9
Insignia NS-CLVR01 Clock Radio with Voice Command
www.insigniaproducts.com
Making connections
Connecting the AC power adapter
Make sure that the AC power outlet matches the AC adapter’s power
specifications (110 V ~ 60 Hz) prior to plugging in the adapter.
To connect the AC adapter:
1 Plug the small DC power connector into the DC IN 9V jack on the
back of your clock radio.
2 Plug the AC adapter into an AC power outlet.
Connecting an external sound source
You can listen to an external sound source, such as a CD, MD, or
non-docking iPod
®
, on your clock radio.
To listen to an external sound source:
1 Make sure that your clock radio is turned off.
2 Connect the external sound source to the AUX IN jack on the back
of your clock radio using a stereo 3.5mm plug cord (not supplied).
3 Press and hold the
/SOURCE button for two seconds to turn on
your clock radio.
4 Press the
/SOURCE button repeatedly until “AUX” appears on
the display.
5 Start playback on the external sound source, then adjust the
volume to a comfortable level. Control playback on the external
audio device.
Setting the clock
You can also set the clock using voice commands. See “Using voice
commands” on page 10.
To set the clock:
1 Press and hold the TIME SET button on the back of your clock
radio. The time blinks on the LCD.
2 Press MIN (minute) to set the minutes and HOUR to set the hours.
Make sure that you set AM/PM correctly.
3 Press TIME SET again. The clock is set.
Note
• Remove both the DC plug and the AC-IN plug to
disconnect the AC power adapter when not in use.
• Use only the supplied AC power adapter to power your
clock radio. (DC 9V, 1A )
NS-CLVR01_10-0138_MAN_ENG_V2.fm Page 9 Tuesday, February 2, 2010 3:04 PM