Filter
Top Products
8
Insignia NS-CLLT01 Digital FM Clock Radio with Dock for iPhone5
www.insigniaproducts.com
Set up your clock radio
Install the backup batteries
The clock radio uses a backup battery system to provide continuous alarm
operation and clock settings in the event of a power failure. If the backup
batteries have been installed and a power failure occurs or the AC cord is
accidentally disconnected, the display will not remain lit, but the current
time and alarm time settings will be temporarily maintained. Otherwise,
you must reset the time and alarm settings.
Make sure that the AC cord is connected. Otherwise all settings may be
lost during battery replacement.
1 Turn your clock radio over so the bottom is facing up, then open the
battery compartment cover located on the bottom of your clock radio
by inserting your fingernail and lifting up on the cover.
2 Insert two "AA" batteries (included) into the battery compartment.
Make sure that the + and – symbols on the batteries align with the +
and – symbols inside the battery compartment.
3 Close the battery compartment.
Caution
• Do not recharge, short, disassemble, or heat the
batteries, or dispose of in a fire.
• Dispose of batteries in the proper manner, according to
federal, state, and local regulations.
• Remove the batteries when the charge is depleted or if
your clock radio will be left unplugged for an extended
period.
• Battery chemicals can cause a rash. If the batteries leak,
clean the battery compartment with a cloth. If chemicals
touch your skin, wash immediately.
• Do not use a mixture of old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), and
rechargable batteries.
NS-CLLT01_14-0316_MAN_V4_ENG.fm Page 8 Wednesday, May 28, 2014 6:40 AM