8
NS-BIPCD02 CD Boombox with Dock for iPhone 4/4s
www.insigniaproducts.com
Setting up your boombox
Powering your boombox
Your boombox can be powered by either the included AC Adapter, or by
using eight “C” sized alkaline batteries. Your boombox only operates on
batteries if the AC adapter is unplugged.
Installing the batteries
To install the batteries:
1 Open the battery compartment on the bottom of your boombox.
2 Place eight “C” size alkaline batteries (not included) into the battery
compartment. Make sure to match the + and - on the battery to the +
and - signs in the battery compartment.
3 Close the battery compartment until it clicks into place.
Connecting the AC adapter
To connect the AC adapter:
1 Plug the small connector at the end of the power cord into the DC IN
jack on the back of your boombox.
2 Plug the AC adapter into a 120/240V, 50/60Hz power outlet.
Caution
• When you replace the batteries, make sure that you use
batteries of the same type and voltage. The batteries are
“C” size alkaline.
• All batteries should be replaced at the same time.
• Dispose of used batteries by following your local
hazardous waste regulations.
• If you don’t plan to use your boombox for an extended
period of time, remove the batteries to prevent damage.
Note
BATT LOW will be shown on the display when the batteries are
lower than 20% capacity.
NS-BIPCD02_14-0811_MAN_V3_ENG.fm Page 8 Tuesday, August 5, 2014 7:22 AM