Insignia NS-14FCT Clock Radio User Manual


 
4
Insignia NS-14FCT TV/DVD Combo
www.insignia-products.com
Power lines
Do not locate an outside antenna system in the
vicinity of overhead power lines or other electric
light or power circuits, or where it can fall onto or
against such power lines or circuits. When
installing an outside antenna system, take
extreme care to keep from touching such power
lines or circuits because contact with them might
be fatal.
Overloading
Do not overload wall outlets and extension cords
because this can result in a risk of fire or electric
shock.
Object and liquid entry
Do not push objects through any openings in
your TV/DVD combo because they may touch
dangerous voltage points or short out parts that
could result in fire or electric shock. Never spill or
spray any type of liquid into your TV/DVD
combo.
Outdoor antenna grounding
If an outside antenna or cable system is
connected to your TV/DVD combo, make sure
that the antenna or cable system is grounded to
provide some protection against voltage surges
and built-up static charges, Section 810 of the
National Electrical Code (NEC), ANSI/NFPA 70,
provides information with respect to correct
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connection to
grounding electrodes, and requirements for the
grounding electrode.
Servicing
Do not attempt to service your TV/DVD combo
yourself because opening or removing covers
may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service
personnel.
Damage requiring service
Unplug your TV/DVD combo from the wall outlet
and refer servicing to qualified service personnel
under the following conditions:
When the power-supply cord or plug is
damaged.
If liquid has been spilled, or objects have
fallen, into your TV/DVD combo.
If your TV/DVD combo has been exposed to
rain or water.
If your TV/DVD combo does not operate
normally by following the operating
instructions. Adjust only those controls that
are covered by the operating instructions
because an incorrect adjustment of other
controls may result in damage and will often
require extensive work by a qualified
technician to restore your TV/DVD combo to
its normal operation.
If your TV/DVD combo has been dropped or
the cabinet has been damaged.
If your TV/DVD combo exhibits a distinct
change in performance, this indicates a need
for service.
Replacement parts
When replacement parts are required, make
sure that the service technician uses
replacement parts specified by the manufacturer
or those that have the same characteristics as
the original part.
Unauthorized substitutions may result in fire,
electric shock, or other hazards.
Safety check
Upon completion of any service or repairs to
your TV/DVD combo, ask the service technician
to perform safety checks to determine that your
TV/DVD combo is in correct operating condition.
Heat
Locate your TV/DVD combo away from heat
sources such as radiators, heat registers,
stoves, or other products (including amplifiers)
that produce heat.
Disc tray
Keep your fingers clear of the disc tray as it is
closing. You may injure yourself.
Connecting
When you connect your TV/DVD combo to other
equipment, turn off the power and unplug all of
the equipment from the wall outlets. Failure to do
so may cause an electric shock and serious
personal injury. Read the owner's manual of the
other equipment carefully and follow the
instructions when making any connections.
Sound volume
Reduce the volume to the minimum level before
you turn on your TV/DVD combo. Otherwise,
sudden high volume sound may cause hearing
loss or speaker damage.
Sound distortion
If your TV/DVD combo outputs distorted sound
for a long time, the speakers may overheat and
cause a fire.
1 Electric service equipment
2 Power service grounding electrode system
3 Ground clamps
4 Grounding conductors
5 Antenna discharge unit
6 Grounding clamp
7 Antenna lead in wire
6
7
5
2
1
3
4