Infinity IL36c Portable Speaker User Manual


  Open as PDF
of 4
 
3
INTERLUDE IL25c, IL36c
IMPORTANT:Make sure all equipment is turned off before
making any connections.
For speaker connections, use a minimum #16-gauge speaker
wire with polarity coding.The side of the wire with a ridge or
other coding is usually considered positive polarity (i.e., +).
NOTE: If desired, consult your local Infinity dealer about speaker
wire and connection options.
To ensure proper polarity,connect each + terminal on the back
of the amplifier, receiver or television to the respective + (red)
terminal on each speaker, as shown in Figure 3. Similarly,
connect the – (black) terminals in the same way.Also, see the
owner’s guides that were included with your amplifier or
receiver to confirm connection procedures.
WIRING THE SYSTEM
Red = +
Black =
–
❶
Loosen Terminal
❷ Insert
Bare End;
Tighten Terminal
Speaker Wire
Marking = +No Marking =
–
Receiver or
Amplifier
(rear view)
Interlude Center
redblack
(one channel shown)
+
–
-
+
FINAL ADJUSTMENTS
CARE OF YOUR SPEAKER SYSTEM
FIGURE 3
–
Interlude series
speakers feature
color-coded
terminals.This
example shows the
most common way
of connecting
speaker wire by
directly inserting
into terminals.
FIGURE 4
– Wiring diagram shows polarity connections for
one channel of a stereo or home-theater system.
IMPORTANT: Do not reverse polarities (i.e.,+ to – or – to +)
when making connections.Doing so will cause poor imaging and
diminished bass response.
Check the speakers for playback first by setting the system
volume control to a minimum level, and then by applying power to
your audio system. Following the directions provided with your
receiver/processor, adjust the center-channel volume so that it
matches the output of the left and right speakers.
Each Interlude series cabinet has a wood-vinyl finish that
does not require any routine maintenance.When needed, use
a soft cloth, dampened with water only, to remove any
fingerprints or dust.
Clean the grille by gentle vacuuming.
NOTE: Do not use any cleaning products or polishes on the
cabinet or grille.
 previous