Infinity IL25c Portable Speaker User Manual


 
3
INTERLUDE IL25c, IL36c
IMPORTANT:Make sure all equipment is turned off before
making any connections.
For speaker connections, use a minimum #16-gauge speaker
wire with polarity coding.The side of the wire with a ridge or
other coding is usually considered positive polarity (i.e., +).
NOTE: If desired, consult your local Infinity dealer about speaker
wire and connection options.
To ensure proper polarity,connect each + terminal on the back
of the amplifier, receiver or television to the respective + (red)
terminal on each speaker, as shown in Figure 3. Similarly,
connect the (black) terminals in the same way.Also, see the
owner’s guides that were included with your amplifier or
receiver to confirm connection procedures.
WIRING THE SYSTEM
Red = +
Black =
Loosen Terminal
Insert
Bare End;
Tighten Terminal
Speaker Wire
Marking = +No Marking =
Receiver or
Amplifier
(rear view)
Interlude Center
redblack
(one channel shown)
+
-
+
FINAL ADJUSTMENTS
CARE OF YOUR SPEAKER SYSTEM
FIGURE 3
Interlude series
speakers feature
color-coded
terminals.This
example shows the
most common way
of connecting
speaker wire by
directly inserting
into terminals.
FIGURE 4
Wiring diagram shows polarity connections for
one channel of a stereo or home-theater system.
IMPORTANT: Do not reverse polarities (i.e.,+ to – or – to +)
when making connections.Doing so will cause poor imaging and
diminished bass response.
Check the speakers for playback first by setting the system
volume control to a minimum level, and then by applying power to
your audio system. Following the directions provided with your
receiver/processor, adjust the center-channel volume so that it
matches the output of the left and right speakers.
Each Interlude series cabinet has a wood-vinyl finish that
does not require any routine maintenance.When needed, use
a soft cloth, dampened with water only, to remove any
fingerprints or dust.
Clean the grille by gentle vacuuming.
NOTE: Do not use any cleaning products or polishes on the
cabinet or grille.