iLuv | 26i1166 | V10M10_IM_EN_09150925 | iLuv
TROUBLESHOOTING GUIDE
No key operation (with the main unit and/or the remote control unit) works
· Press
on the remote control to set the player to the standby mode and then switch back on.
· Slide the POWER OFF/ON switch to the OFF position, then set back to ON position.
· Key lock function is activated, slide the HOLD switch to DOWN position to release the key lock
function.
Audio and/or subtitle language are not shown on the disc or not in the setup menu.
· If the audio and/or subtitle language does not exist on the language selected in the setup menu,
it will not be seen or heard.
No subtitles
· Subtitles are not available on all discs.
· Subtitles are cleared from the LCD screen. Perform the steps in the subtitle setup instruction to display
the subtitles.
Alternative audio (or subtitle) language fails to be selected.
· An alternative language will not be selected with discs featuring only one language.
The movie angle cannot be changed.
· This function is contingent on software availability. Even if a disc has a number of angles recorded,
these angles may be recorded for specic scenes only.
TROUBLESHOOTING GUIDE
No Power
· Insert the AC power plug securely into the wall power outlet
iPod isn’t recharged.
· Check whether your iPod is properly installed in the dock.
Play does not begin even after
is pressed or it starts to play and stops immediately
· Condensation may have formed. Allow 1 to 2 hours for the player to dry out.
· The disc may be incompatible with this unit. This player can only play DVD, VCD and CD formats.
· The disc may be dirty and require cleaning.
· The disc may be improperly loaded. Be certain it has been loaded with the label side up.
No picture on the LCD screen
· Ensure that the disc or iPod mode is properly set.
· Ensure that the iPod is properly connected.
No sound or distorted sound
· Ensure that the disc or iPod mode is properly set.
· Ensure that the iPod is properly connected.
· Ensure that the input settings for the iPod are properly set.
Picture is distorted during the rapid advance or rapid reverse
· The picture will be somewhat distorted at times. This is normal.
No rapid advance (or rapid reverse) playback
· Some discs may have sections which prohibit the rapid advance (or rapid reverse).
Remote Control Does Not Work
· Ensure that the batteries are installed with the correct polarities (+ and –).
· The batteries may be exhausted. Replace them with new ones.
· Point the remote control unit at the remote control sensor and attempt operation.
· Operate the remote control at a distance of less than 6m from the remote control sensor.
· Remove the obstacles between the remote control unit and remote control sensor.