iLive ITP280B MP3 Docking Station User Manual


 
  
16”
ITP280B
ITP280B
screws
studs
mounting
bracket
spacer
MOUNTING THE BAR SPEAKER TO A WALL
Getting Started
1 Use the TAPE MEASURE to decide how
high you’d like to hang the bar speaker on
the wall.
The bar speaker must be hung within 6 feet of
an AC power outlet for the attached AC power
cable to reach.
2 Use the STUD FINDER to locate 2 parallel
wooden studs to screw the mounting
brackets into.
3 Mark the wall at the center of the studs
using the PENCIL.
4 Line the LEVEL up on both of your marks
to make sure they are level. If they’re not,
adjust the marks as needed to make them
level.
5 After you’ve double checked your markings,
DRILL through the top hole on both
mounting brackets directly into the marks
you’ve made on the wall.
6 If you are using the brackets only and no
spacers, use the included short screws.
If you are using any of the spacers or
combination of the spacers, use the long
screws.
7 Use the LEVEL to level each of the hanging
brackets, then drill the second screw
into the bottom hole on both mounting
brackets.
8 Slide the bar speaker onto the mounting
brackets, and make sure there is a rm and
stable connection before letting go of the
bar speaker.
9 Finally, use the LEVEL to conrm that the
bar speaker is level.