Filter
Top Products
Using The Remote Control Unit
10
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory.
When the remote control stops operating or its range seems
reduced, replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2.
Press to release the battery door latch.
3. Insert 1 “CR2032” 3-volt lithium battery. Make sure the
polarity (the + and – side of the battery) is correct.
4.
Replace the battery door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Warning :
- Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water, fire, or high
temperatures & not handled appropriately.
- Do not place loose batteries in a pocket, purse, or other container containing metal objects, mix with used or other
battery types, or store with hazardous or combustible materials.
- Store in cool, dry, ventilated area.
- Follow applicable laws and regulations for transport and disposal.
Install Remote Control Battery
Battery door
OPERATING THE REMOTE CONTROL
The Remote Control controls basic functions on the iP51 and certain iPhone/iPod functions when the iPhone/iPod is docked
in the iP51. For best results, aim remote control towards the receiver.
Power On/Off/ Alarm reset
Play/Pause
Select Down/Rew
iPod navigate “menu”
Presets
Radio/Aux
Sleep
Snooze/Dimmer
Random
EQ
iPod navigate “up” & “down”
Mute sound
Select Up/FF
iPod navigate “enter”
Increase volume
Decrease volume
Repeat