Filter
Top Products
Listening to Bluetooth Music
Listening to other portable audio devices
7
You need to pair your Bluetooth device with the iP47 before you can auto-link to play/stream Bluetooth music
through the iP47. Pairing creates a permanent “bond” so two devices can always recognize each other.
Note: the iPhone does not support the A2DP protocol, so it cannot be used to stream music. See
Listening to your iPhone to play your iPhone through the iP47.
Pairing:
1. Press and hold the Button for 4 seconds to begin pairing operation. The Bluetooth and “pairing” icons
will flash.
2. Activate Bluetooth on your device according to the device’s user manual to link to iP47 . You may need to
input the iHome device pass code: “1234”.
3. Once connected, the Bluetooth Icon will remain.
4. iP47 will auto link with the last linked device when that device is in range.
Playing Bluetooth Music:
1. Once your device and the iP47 are linked you can start to play Bluetooth music through the iP47.
2. Turn on the iP47 and press the Mode button until “Bluetooth” appears in the lower part of the display .
3. Press the Button on the iP47 or on the remote control to play your Bluetooth-enabled device. The display
will show “Bluetooth” and a Play Icon. (Depending on the Bluetooth device you are using, you may need
to manually go into media player mode on your device to make it work properly).
4. Press the Button again to pause play; press again to resume it.
5. Press the or Button on the iP47 or on the remote control to adjust the system volume.
6. Press or Button on the iP47 or on the remote control to go to the next or previous track.
Please remember to turn off Bluetooth device manually.
NOTE: The iP47 must be in Bluetooth mode to play a Bluetooth-enabled device.
You can play a MP3 player or other portable audio device through the iP47 via the Line in Jack.
1. Plug one end of an audio patch cord (available at http//:www.ihomeaudio.com) into the headphone or
line-out jack on your device and the other end of the patch cord into the iP47 Line in Jack, located on the
back of the unit.
2. Turn on the iP47 and press the Mode button until “Line in” appears in the lower part of display, indicating
Line in playing mode.
3. Turn on and play your device.
4. Press the or Button on the iP47 or on the remote control to adjust the system volume. You may need
to adjust your device volume, too.
Remember to turn off your device when you are done playing it.