Filter
Top Products
5
Setting Up the iP43
Connect iP43 to Power Source
Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120V AC wall socket. Adaptor must
be plugged in to operate unit. The iP43 does not operate on batteries (a battery back up system maintains clock settings
during power failures).
This unit is a preset clock: the clock is preset at the factory. It’s simple to match the Time Zone setting to your location (US
only).
1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, manually set the DST Switch located
at the back of the unit to +1 to add an hour or to -1 to subtract an hour. A DST adjust screen appears briefly.
2. Press and hold the Time Zone Button located on the back of the unit until the Time Zone flashes on the lower part of the
display. Turn the Set Wheel to select your time zone. Note: Time Zone is disabled when clock display is set to 24 hours
(see step 5 under Setting Time).
3. Press the Time Zone Button again (or no button within 10 seconds) to exit the time zone setting mode.
4. If the displayed time is not correct, please see “Setting Time and Calendar manually” section below.
Sync Time to iPhone/iPod
The iP43 Time Sync feature allows you to sync the time setting on the iP43 to the time from your iPhone or recent model iPod
Touch, iPod Nano and iPod Classic (older iPod models such as iPod mini do not support this feature).
1. Dock your iPhone or iPod
2. Press the Time Sync Button located at the back of the unit. “SYNC” will flash on the display
3. The iP43 will sync to the time on your iPhone/iPod. Once sync is completed,“SYNC OK” will appear on the display.
4. If sync was not successful, “Failed” will appear on the display. If this happens, please try again, with a different iPhone/iPod
if needed. If time sync still fails, please set time manually (see below).
NOTE: The iPhone is constantly updated to current time via cell phone towers. The time on your iPod is only accurate to the
last time it was synced to a computer. It’s possible to have up to 59 seconds difference between the iP43 and synced
iPhone/iPod.
Setting Time and Calendar manually
1. Press and hold the Time set/sync Button located at the back of the unit until the time flashes on the display.
2. Turn the Set Wheel to the correct time. Remember to set the correct AM or PM time. The AM/PM Indicators appear to
the left of the time display (except when clock display is set to 24 hour mode-- see step 5).
3. Press the Time set/sync button again. The year will flash. Turn the Set Wheel until the current year is displayed.
4. Press the Time set/sync button again. The month and date will flash. Turn the Set Wheel until the current month/date
is displayed.
5. During Time set, press either the or button to toggle the clock display format to 12 hours or 24 hours.
6. Press the Time set/sync button again (or no button within 10 seconds) to exit the time/calendar setting mode.