Filter
Top Products
3
Color Change Mode
1. Place proper insert for your iPhone or iPod (see insert table on Quick Start Section) in Dock, then gently dock playing
iPhone or iPod. The unit will turn on and you will hear your music. When docked,
iPhone or iPod will charge until fully
charged. The iPhone or iPod will not overcharge.
2. If iPhone or iPod is not in play mode, press the Button on the iP15 to turn on the unit and press play on your
iPhone
or iPod
. The power on indicator will light up to show the iP15 is on.
3. Press the or Button Volume to adjust the volume.
4. To switch off the unit, press the Button again.
Playing and Charging your iPhone/iPod
1. Plug one end of an audio patch cord (available at www.ihome.com) into the headphone or line-out jack on your audio
device and the other end of the patch cord into the iP15 Line-in Jack located on the back of the unit.
2. Press the Button on the iP15 to play your audio device. The power on indicator will light up to show the iP15
is on. Place your device in play mode.
3. Press the or Button to adjust the volume.
4. To switch off the unit press the Button again. Remember to turn off your audio device, too.
NOTE: DO NOT play a line-in device while iPhone/iPod is playing or you will hear both audio sources at once.
Using the Line-in Jack
There are 5 color settings. Press the Color Button to cycle through them. The settings are: slow color change (default),
fixed color (press the Color Button when the desired color is showing to select that color), pulse to music, fast color
change and light off.