Filter
Top Products
iH9 IB_1115.fh10 11/27/07 3:59 PM Page 7
Using The Remote Control Unit
The Remote Control controls basic functions on the iH9 and certain iPod
®
functions when the iPod
®
is docked in the iH9.
For best results, use the remote control within 12 feet of the unit.
5
Install/Replace the Remote Control Batteries
The remote control batteries are already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the batteries with new ones.
1. The battery door is located on the back end of the unit.
2. Press to release the battery door latch.
3. Insert one “CR2032” 3-volt lithium batteries. Make sure the polarity (the + and – side
of the battery) is correct.
4. Replace the battery holder back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Battery
door
ᕡ Power On/Off Alarm Reset Button: Turns iH9 ON or OFF or resets alarm when alarm
is sounding
ᕢ Fwd/Rev Button: Skip to previous or next track, or HOLD to scan current playing track;
Also controls set wheel functions (changing settings, tuning radio, etc.)
ᕣ Menu Button: Press to access iPod Menu functions
ᕤ Preset Button: Cycles through AM or FM radio presets
ᕥ Radio Button: Selects Radio (AM and FM radio bands) and line-in functions
ᕦ EQ Button: Set Treble, Bass, 3D sound effect and Balance settings for best sound
ᕧ Snooze/Dimmer Button: Snooze mode when alarm sounds, otherwise dims display
ᕨ Random Button: Press for random play
ᕩ Repeat Button: Press for repeat play (press again to repeat all)
µ Sleep Button:
Press to select an amount of time before the iH9 shuts off: 120, 90, 60,
30 or 15 minutes
¸ Volume – Button: Lowers volume level
¹ Volume + Button: Raises volume level
Ƹ Enter Button: Press to select iPod menu function
ƹ Up/Down Button: Press Up or Down to scroll iPod menu
ƺ Play/Pause Button: Plays track. In play mode, press to pause
ƻ Mute Button: Toggles sound ON or OFF
ᕡ
ƺ
ᕢ
ᕢ
ƻ
ᕣ
ƹ
ƹ
Ƹ
¹
µ
ᕤ
ᕥ
ᕦ
ᕧ
ᕨ
ᕩ
¸