iHome iH30 MP3 Docking Station User Manual


 
Listening to non-docking iPod or other portable audio devices
If you are using an iPod without a docking port or other MP3 player or other portable audio device, you can
still play it through the iH30 via the Line-in Jack.
1. Plug one end of the audio patch cord (included) into the headphone or line-out jack on your device and the
other end of the patch cord into the iH30 ¹ Line-in Jack, located on the front of the unit.
2. Press Power On/Off Button on main unit or remote to turn iH30 on.
3. Press the Ƽ Mode Button until you can see “AU” showing on the display, indicating AUX playing mode.
4. Press the Volume+ and Volume– Button on main unit or remote control to adjust the system
volume. You may need to adjust your device volume too.
5. To turn off the unit, press the Power On/Off Button on main unit or remote control to turn it off. Please
remember to turn off your device, too.
Listening to FM Radio
Note: Extend FM rod antenna fully for best reception. In some areas, it may be difficult to get stereo sound
without interference. If this proves a problem, set the Mono/Stereo FM switch on the back of the unit to
Mono.
1. Press the Power On/Off Button on the iH30 or remote to turn unit on.
2. Press the Ƽ Mode Button on the iH30 or remote control until you can see a radio frequency showing on
the display.
3. Use ² Tune Up or ´ Tune Down Button to tune in to the desired station.
4. Press and hold the ² Tune Up or ´ Tune Down Button for appox. 2 seconds, it will start to auto seek
available stations and will stop when a clear one is found.
5. Press the Volume+ and Volume– Button on the iH30 or remote control to adjust the iH30 volume.
Press the ƽ Mute Button to mute the output; press the button again to release it.
6. To turn off the unit, press the Power On/Off Button on the iH30 or the remote control to turn it off.
12