iHome iH22 Clock Radio User Manual


 
Using the iH22
Snooze Operation
1. Press and hold the Snooze/Dimmer Button for a few seconds to set snooze time. Press the or Button to set
the snooze timer from 1 to 30 minutes.
2. Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again after the set
snooze time. Snooze can be pressed several times during the 1 hour alarm cycle.
Sure Alarm
The iH22 has a sure alarm feature. If backup batteries are installed, the buzzer alarm will still sound in the event of power
failure.
Charging your iPod
Note: Please make sure you are using the correct insert for your iPod (see Installing iPod Insert) and that the iPod is properly
docked into the iH22. Failure to do so may damage your iPod.
1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges (until fully charged). Back up
batteries will NOT charge iPod. Note that non-docking iPod models will NOT charge.
Listening to your iPod
1. Dock your already playing iPod. The iH22 will automatically turn on and you will hear the music playing from your iPod.
Note: If the volume on the playing track is too low, iH22 may not detect that your iPod is in play mode. If this happens,
press the Button on the main unit to play it.
2. When the iPod is docked and in standby mode, press the Button on the iH22 to play it. The will appear on the
display, indicating iPod play mode.
3. Press the Button again to pause play; press again to resume it.
4. Press the Volume and Volume Button to adjust the system volume.
5. Press the or Button on the unit to go to the next or previous track. Press and hold while a track is playing for
high speed forward or reverse music search of the current track.
6. To turn off the unit, press the Button. The iPod will continue charging while in the dock.
Listening to non-docking iPod or other portable audio devices
If you are using an iPod without a docking port or another MP3 player or portable audio device, you can play it through the
iH22 via the MP3 Line-in Jack located on the back of the unit.
1. Plug one end of an audio patch cord (available at www.ihomeaudio.com) into the headphone or line-out jack on your
device and the other end of the patch cord into the iH22 MP3 Line-in Jack.
2. Press the Button to turn the iH22 on.
3. Turn on and play your device.
4. Press the Volume and Volume Button to adjust the system volume. You may need to adjust your device volume,
too.
5. To turn off the unit, press the Button. Please remember to turn off your device, too.
5