Filter
Top Products
4
Using iH16
Install AC Adaptor
Connect the AC adaptor cable plug into the jack on the back of the ih16, then plug the AC
adaptor into the wall outlet.
Install iPod Insert
Your iH16 comes with a double-sided insert to ensure certain iPod models fit properly in
the dock. To place an insert:
1. Identify the side of the insert that matches your iPod model (see table on page 1).
2. Gently press the iPod insert into the dock with the proper side facing the connector
pins.
3. Carefully place your iPod into the dock. The iPod must not be in a case or “skin”.
Install iPod Insert
Charging Your iPod
1. Dock an already playing iPod and the iH16 will automatically turn on.You will hear the music playing from your iPod.
Note: If the volume on the playing audio is too low on the iPod, the iH16 may not detect that the iPod is in play mode.
Press the button once to play iPod.
2. When the iPod is docked and in standby mode, press the button on the iH16 to play your iPod.
3. Press play/pause on your iPod to pause play; press again to resume it.
4. Press the or buttons on the iH16 to adjust the system volume.
5. To turn off the unit, press the button on the iH16. Your iPod will continue charging while in the dock.
Listening to Your iPod
Installing/Replacing Batteries for Portable Operation
The iH16 uses 4 “AA” batteries for portable operation. The iH16 will not charge your iPod while operating on batteries.
If sound becomes weak or distorted, it is time to replace the batteries.
• Open the battery compartment cover located on the bottom of the unit.
• Insert 4 “AA” batteries as indicated.
• We recommend the use of alkaline batteries for longer life.
NOTE: To save battery life, when running on batteries, unit will automatically
power OFF after 3 minutes of non-use (no song playing).
Batteries information:
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.
Note: Please make sure you are using the correct side of the insert for your iPod model, if needed (see Install iPod Insert)
and that your iPod is properly docked into the iH16.
1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged. iPod will
not be overcharged. Unit will not charge iPod when operating on batteries.